Hole Pro Shield Vacuum Adapter
Description
For use with Hole Pro shields for dust control in HEPA required environments
Using a 1-3/8" (35mm) hole saw, cut a hole in the top of the Hole Pro shield at a point where the hole saw pilot bit is exactly 1-1/4” (32mm) from outer edge of the shield. The adapter’s hole location needs to be close to the inner edge of the shield while leaving room for the Hole Pro Vacuum Adapter’s flange. to sit flat. Vacuum suction will be best at the edge of the shield and this location helps to keep the vacuum hose out of the way while cutting holes using the shield. |
5 Stars | 3 reviews |
3 Most Useful Customer Reviews
Tom
various sources of dust is bad for the only lungs you'll ever have. When work is
done in an inhabited dwelling (lots of recessed and ceiling fan lighting is done
in bedrooms) there is an additional incentive for protecting the lungs of your
customers as well as additional clean up labor. Beside wearing a respirator (which
only protects you), you now have the option to install this VACUUM ADAPTER on your
Hole Pro Shield cutting/dust catching tool. Sadly, most of the electricians do
not understand what dust is doing to their lungs before it is too late.
This vacuum adapter can be easily installed by drilling a hole with a hole saw
on the bottom of the Hole Pro transparent shield, fastening the adapter to the
shield with a plastic nut provided inside the adapter kit.
My Fein vacuum came with a RUBBER SLEEVE that makes an easy, fast connection
between the vacuum wand and the vacuum adapter. I have used electrical tape
wrapped around the bottom part of the adapter in order to make the connection
air tight, strong enough to hold the weight of the vacuum hose, and easy to
dis/connect. Great product, great company.
Jack