0 $0.00
5-1/2" Carbide Hole Saw Cutter
George
I used this on inch thick plywood subflooring and was able to cut quickly using a DeWalt 18v cordless drill on its medium speed setting. Tried first hole on the lowest speed setting and it was OK but would jerk a little when it hit a harder section of the plywood. At the middle speed setting it was much smoother. Even on the low speed setting it was a whole lot smoother and easier to use than even the small sizes of the Lenox One Tooth hole cutters which are plain scary to use in a hand held drill.
Clean holes in seconds and the cut plug comes out in seconds. Long tooth life even in MDF, particle board, and plywood. I will never go back to using bi-metal hole saws for anything but metal.
Clean holes in seconds and the cut plug comes out in seconds. Long tooth life even in MDF, particle board, and plywood. I will never go back to using bi-metal hole saws for anything but metal.
My Account
Reviews
- I have purchased 5 of these brand hole saws to date in different sizes, and they are very well...Lars
- Read All Reviews...
Testimonials
The X-230+ with the 5/8" threaded arbor shaft allows me to use a 1" carbide grit hole saw and get...
Jim
It will save you time and money, plus provide exact size holes every time.
Bill, Home Theater Installer
I cut 9 holes in drywall. 3 at 3", 4 at 6.5", 2 at 9.5". It was wonderful. Clean cuts and clean...
John S, Contractor
I have had great success with the product. It works wonderfully... two contractors watched me...
Cliff - Electrician
Its a wonderful product this will cut down 65% of my time thanks so much
J. Rivera
