0 $0.00
7/8" Metal Hole Saw Cutter
Jack
We cut hundreds of holes in steel studs and the bi-metal hole saws wear out quickly. After switching to the Greenlee carbide hole cutters things went a lot faster and we were not making frequent runs to the store for more hole saws. I tried one of the Blue Boar Metal Pro hole cutters over the last two weeks and it cuts every bit as good as the Greenlee we have been using.
Extra touch is the use of a 1/4" pilot bit and being able to use the shaft or put the hole cutter on a regular hole saw arbor. Being able to replace a broken bit in the field is easy with a 1/4" pilot bit - Greenlee uses 6mm which is a lot harder to find. With the use of a 7/16" shank hole saw arbor I can use a 5" or 12" extension when I need to make a hole in a spot where the electric drill does not fit.
Extra touch is the use of a 1/4" pilot bit and being able to use the shaft or put the hole cutter on a regular hole saw arbor. Being able to replace a broken bit in the field is easy with a 1/4" pilot bit - Greenlee uses 6mm which is a lot harder to find. With the use of a 7/16" shank hole saw arbor I can use a 5" or 12" extension when I need to make a hole in a spot where the electric drill does not fit.
My Account
Reviews
- I have used masonry drills on stucco and it is a time consuming process to make lots of little...Stephen
- Read All Reviews...
Testimonials
Finally a tool that cuts through plaster like butter without the usual chipping and cracking....
J Metzger
I cut 9 holes in drywall. 3 at 3", 4 at 6.5", 2 at 9.5". It was wonderful. Clean cuts and clean...
John S, Contractor
Wish I had one of these years ago. Makes life alot easier. Thank you guys.
C. Faust
Thanks so much for the Great product! This is the 2nd one I have purchased this year. We install...
Mark, Precision Heat
I have had great success with the product. It works wonderfully... two contractors watched me...
Cliff - Electrician
